HERENTALS, BELGIUM (8:30 A.M. to 4:30 P.M.) CET
Phone: + 32 (0) 14 25 99 11
Declaration of Conformity
We declare, under our sole responsibility, that the product identified in this declaration, and to which this declaration relates,
are in conformity with the protection requirements of Council Directive 98/37/EEG
The manufacturer, Pentair Water Belgium N.V., has the right to modify the products without previous notice.
© 2009 Pentair Water Pool, Inc. All rights reserved. This document is subject to change without notice.
Trademarks and disclaimers: Sta-Rite
companies in the United States and/or other counties.
Warranty conditions: please visit our website
IMPORTANT SAFETY PRECAUTIONS
THESE OPERATING INSTRUCTIONS CONTAIN IMPORTANT INFORMATION ON THE SAFE, PROPER
AND ECONOMICAL OPERATION OF THE SWIMMING POOL PUMPS. STRICT OBSERVATION OF
THE OPERATING INSTRUCTIONS WILL HELP TO AVOID DANGERS, REDUCE REPAIR COSTS,
SHUTDOWN TIMES AND INCREASE THE RELIABILITY AND WORKING LIFE OF THE PRODUCT.
Check carton for any evidence of damage due to rough handling in shipment. If carton or any pump
components are damaged, notify the carrier immediately.
Failure to follow the safety instructions may result in serious adverse health effects,
or even serious or fatal injury. Failure to follow the safety instructions will in all cases
invalidate all guarantees and liability on the part of the manufacturer.
This pump is equipped with a mechanical seal.
Avoid dry run of the pump. Always ensure pump is filled zwith water.
Please follow instructions for filling up the pump according to installation and instruction
Only to be used to circulate swimming pool water.
Install the pump as near to the pool as practical.
Use a direct and short suction line with continuous slope in order to avoid long priming times.
The pump should be placed on a flat, solid foundation, high enough to prevent flooding of the
Install the filter and pump in a sheltered location, ensuring ventilation and adequate access for
Do not mount electrical controls directly over pump.
Provide adequate floor drainage to prevent flooding.
Size all piping adequately and keep the number of elbows to a minimum.
Independently support the pipe near the suction and discharge of the pump in order to reduce the
Avoid overtightening pipe connections. Use only pipe sealants formulated for plastics. Do not use
petroleum based products. It is essential that the suction line is free of air leaks. The suction line
should always be at least the same size as the suction inlet of the pump.
is a trademark and/or registered trademark of Pentair Water Pool, Inc. and/or its affiliated