Download  Print this page

STA-RITE MAX-E-PRO Owner's Manual

Max-e-pro p6ra/p6ea/p6e series centrifugal pumps with integral trap
Hide thumbs

Advertisement

MAX-E-PRO™
CENTRIFUGAL PUMPS WITH INTEGRAL TRAP
O W N E R ' S M A N U A L
INSTALLATION, OPERATION & PARTS
Series P6RA, P6EA, and P6E
See Page 2 for Model Numbers
This manual must be given to the owner/user of this pump
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
© 2010 Pentair Water Pool and Spa, Inc. All rights reserved.
1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000
10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000
Max-E-Pro™, Sta-Rite® and Pentair Water Pool and Spa® are registered trademarks of Pentair Water Pool and Spa, Inc. and/or
its affiliated companies in the United States and/or other countries. Plasto-Joint Stik® is a registered trademark of La-Co
Industries, Inc. and Teflon® is a registered trademark of E.I. Du Pont De Nemours and Company Corporation. Unless noted,
names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between
the proprietors of these names and brands and Pentair Water Pool and Spa, Inc. Those names and brands may be the
trademarks or registered trademarks of those parties or others.
*S691*
Printed in U.S.A.
03/12/2010
S691 (Rev. B)

Advertisement

loading

  Also See for STA-RITE MAX-E-PRO

  Related Manuals for STA-RITE MAX-E-PRO

  Summary of Contents for STA-RITE MAX-E-PRO

  • Page 1 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000 Max-E-Pro™, Sta-Rite® and Pentair Water Pool and Spa® are registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other countries. Plasto-Joint Stik® is a registered trademark of La-Co Industries, Inc.
  • Page 2: Technical Support

    MANUAL CAREFULLY! potential for personal injury. The Sta-Rite ‘P6RA’, ‘P6EA’, ‘P6R’ and ‘P6E’ Series Self-priming Centrifugal pumps: warns about hazards that will cause death, serious personal injury, or major property damage if •...
  • Page 3: Installation

    NOTICE: These parameters apply to Sta-Rite NOTICE: Port threads are: Internal - 2" NPT for direct equipment only. For non-Sta-Rite equipment, consult connection to pipe. External - 3-1/4" Buttress. Fits Sta-Rite manufacturer. U11-200P Union Collar for quick disconnect pipe connection.
  • Page 4: Pool Pump Suction Requirements

    Fittings: Fire and burn hazard. Modern motors run at Fittings restrict flow; for best efficiency use fewest high temperatures. To reduce the risk of fire, do not allow possible fittings. leaves, debris, or foreign matter to collect around the pump motor. To avoid burns when handling the motor, let Avoid fittings which could cause an air trap.
  • Page 5 Water Velocity Voltage/Phase Voltage at motor must be not more than 10% above or The maximum water velocity through any suction outlet below motor nameplate rated voltage or motor may must be 1.5 feet per second unless the outlet complies overheat, causing overload tripping and reduced with the latest ASME/SNSI Specification for Suction component life.
  • Page 6 1. Turn off power. BONDING 2. Remove the motor end cover. To Wire a Single Speed, Single Voltage Motor There are two terminals labeled L1 and L2. Attach the power GREEN leads to these terminals. Either wire may attach to either GROUND SCREW terminal.
  • Page 7 Ground (Green) Low Speed Volt Back of Lines Common motor with Power Supply for Optional Timer. Terminal Board High Speed Circuit Remote SPDT Protector Switch If using timer, Connect Timer Motor to Low Speed Only 4558 0304 Minimum switch and timer amp rating must equal Branch Fuse Rating given in "Recommended Fusing and Wiring Data"...
  • Page 8 TABLE II - RECOMMENDED FUSING AND WIRING DATA - P6EA MODELS Serv.to Motor-Dist.in Ft(M) Motor Branch Fuse Max Load Voltage/ 0-100' 101-200' 201-300' Rating Amps* Amps Hz/Phase (0-30 M) (30-60 M) (60-90 M) P6EA MODELS 13.8 115/60/1 12(3) 10(5.5) 8(8.4) 1-1/2` 16 115/60/1 12(3)
  • Page 9: Operation

    OPERA TION NEVER run pump dry. Running pump dry may To prevent damage to the pump and filter and for proper damage seals, causing leakage and flooding. Fill operation of the system, clean pump strainer and skimmer pump with water before starting motor. baskets regularly.
  • Page 10: Pump Service

    No. 19, Page 13). Clean pump and trap basket Pump should only be serviced by qualified personnel. thoroughly; replace trap cover. For best results, use only genuine Sta-Rite factory NOTICE: Tighten trap cover by hand only (no parts. wrenches)! Use a rubber mallet only if necessary to remove cover! If pump is not anchored, use caution Be sure to prime pump (Page 9) before starting.
  • Page 11: Pump Reassembly/Installing New Seal

    periodic cleaning of strainer basket. If shaft seal is worn Pump Reassembly/Installing New Seal or damaged, repair as follows: 1. Ceramic seat must be clean and free of dirt, grease, dust, etc. Wet outer edge of rubber cup on ceramic Pump Disassembly/Removing Old Seal seat with small amount of liquid detergent;...
  • Page 12: Troubleshooting Guide

    TROUBLESHOOTING Electrical: 9. Pump may be running too GUIDE slowly; check voltage at Read and understand safety and operating motor terminals and at instructions in this manual before doing any work meter while pump is on pump! running. If low, see wiring instructions or consult Only qualified personnel should electrically test power company.
  • Page 13: Repair Parts List

    P6E, P6EA, P6RA MAX-E-PRO POOL PUMP 1/2 through 3 HP Models Box A REPAIR PARTS LIST Part Part For quick disconnect pipe Description Qty. connections, purchase separately: Pkg. 188 2" Slip 1/2 Union Kit or Motor See page 14/15 Pkg. 189 2" NPT 1/2 Union Kit.
  • Page 14 Part are common to all models listed except as noted; Key Nos. 1(Motor), 10(Impeller), and 11(Diffuser) are listed below. Motor No. Impeller Diffuser Part are common to all models listed except as noted; (Key No. 1) (Key No. 10) (Key No. 11) Model No.
  • Page 16 READ, THEN KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE *S691* S691 (Rev. B) 03-12-10...