62.5 mm
(2.5 in.)
22.5 mm
(0.9 in.)
Rev 4 Aug.15
For simple installations in good LTE coverage, an Ethernet-connected
configuration PC running your favorite speed-test application and ACEmanager to
determine network signal strength, cell info, and signal quality will help narrow
down some of the location options.
Mounting the ES Series device
Warning:
This ES Series device is not intended for use close to the human body.
Antennas should be at least 8 inches (20 cm) away from the operator.
Mount the ES Series device where:
•
There is easy
access to connect to the enterprise router and to the antennas
(see
Locating the ES Series device
•
The front panel LEDs are easily visible
•
There is adequate airflow
•
It is kept free from direct exposure to the
etc.
The ES Series device has four mounting holes to attach it to a mounting surface.
These holes are accessible from the top of the device and screws are provided for
mounting.
0
5.2 mm (0.2 in.)
0
Figure 3-2: ES Series device bottom view, showing mounting holes
Antenna Installation
If the location chosen in
the antennas can connect directly to the ES Series device, then follow the
instructions in
Connecting the Antennas
V-formation.
If you are cabling the antennas to the ES Series device, your AirLink authorized
reseller may be able to assist with your cabling and installation.
on page 28).
elements, such as sun, rain, dust,
136 mm (5.4 in.)
Locating the ES Series device
on page 16 to connect the antennas in a
On-site Installation and Setup
Mounting holes
diameter: 5.3 mm (0.2 in.)
on page 28 is such that
29