Installation - Zanussi ZCG552GNC User Manual

Installation

WARNING!
Refer to Safety chapters.
Technical data
Dimensions
Height
Width
Depth
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
For the minimal distances of fitting check the
table.
D
Minimum distances
Dimension
A 650
B 150
C 2
D 400
E 450
www.zanussi.com
894 - 912 mm
550 mm
600 mm
A
E
B
C
mm
Dimension
F
Levelling of the appliance
Use small feet on the bottom of appliance to set
the appliance top surface level with other
surfaces.
The stability chain
CAUTION!
Install the stability chain to prevent
the appliance from tilting. The
stability chain only works when the
appliance is put in a correct area.
F
1. Measure down 180 mm from the appliance
top surface, then measure right 30 mm.
2. Mark the position of the wall and this gives
anchor point for the stability chain.
Other technical data
WARNING!
These instructions are only valid in
the countries whose symbols appear
on this booklet's cover.
Gas cate-
gory:
mm
less than 400
180 mm
30 mm
I2H
21