Optoma ZU650 User Manual page 41

UsInG THE PRoJECToR
Communications menu
lan
Configure the local area network (LAN) settings.
‡ DHCP: Turn the DHCP ON/OFF.
‡ IP address: Select an IP address.
‡ subnet mask: Select subnet mask number.
‡ Default Gateway: Select the default gateway of the network connected to the projector.
maC address: Display the network MAC Address value.
‡
‡ apply: Apply Network settings.
Wlan
Configure the wireless local area network (WLAN) settings.
‡ Enable: Enable/Disable WLAN.
‡ start IP: Start of IP Address.
‡ End IP: End of IP Address.
‡ subnet mask: Assign Network Subnet Mask.
‡ Default Gateway: Assign Network Default Gateway.
‡ maC address: Display network MAC Address value.
‡ ssID: Assign Network Service Set Identifier.
network
Configure the general network settings.
Projector name: Display the projector hostname for Network.
‡
‡ Restart network: Restart the network.
‡ network factory Reset: Perform factory reset on the network settings. The Projector Name, LAN IP,
WLAN IP, and SNMP settings will be reset
serial Port baud Rate
Select the serial port and baud rate.
serial Port Path
Select the serial port path from either RS232 or HDBaseT.
PICTURE
LAN
WLAN
Network
oUTPUT
Serial Port Baud Rate
Serial Port Path
Projector Address
sETUP
oPTIon
Communications
19200
RS232
0
41
English