Digital Link Terminal Connection (Lf80 Series Only) - Panasonic TH-42LF8U Operating Instructions Manual

Pin assignments and signal names for USB Terminal
Pin No.
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5V/1A can be supplied to an external
device when receiving images.
●
If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off / on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
24
English
1 2 3 4
Signal name
DIGITAL LINK terminal connection
(LF80 series only)
Twisted pair cable transmitters such as the Panasonic
Digital Interface Box (ET-YFB100G) or the DIGITAL
LINK Switcher (ET-YFB200G) use twisted pair cables
to transmit inputted video and audio signals, and
these digital signals can be input to the Display via the
DIGITAL LINK terminal.
DIGITAL LINK
AUDIO OUT
PC to control the unit
Example: Panasonic ET-YFB100G
PC
Video Cassette Recorder
DVD Player
Note
●
When connecting with DIGITAL LINK, be sure to
configure each of the [Network settings] settings. (see
page 54)
For the cautions for DIGITAL LINK setting and
connection, see page 72.
● Corresponding signal for DIGITAL LINK input is the
same as that of HDMI input. (see page 96)
LAN
Analogue signal is output
as Digital signal.