Table of Contents
Advertisement
Note
●
Component video signal is supported with this
terminal (Mini D-sub 15P).
Change the [Component/RGB-in select] setting in
the [Signal] menu to [Component] (when Component
signal connection) or [RGB] (when RGB signal
connection). (see page 50)
●
Additional computer, cables and conversion adapter
shown are not supplied with this set.
●
If the computer being connected is not DDC2B-
compatible, you will need to make setting changes to
the computer at the time of connection.
There is no need to use an adapter for computers
with DOS/V compatible Mini D-sub 15P terminal.
●
Do not set the horizontal and vertical scanning
frequencies for PC signals which are above or below
the specified frequency range.
●
For audio, the AUDIO IN 1 / AUDIO IN 2 terminal can
be used. (For [Audio input select] function, see page
76.)
Pin assignments and signal names for PC Input
Terminal (Mini D-sub 15P)
Pin No.
R (P
G (Y)
B (P
NC (not connected)
GND (Ground)
GND (Ground)
GND (Ground)
GND (Ground)
+5 V DC
GND (Ground)
NC (not connected)
SDA
HD/SYNC
VD
SCL
24
English
5
4
3
2
1
10
9
8
7
6
15 14 13 12 11
Signal Name
/C
)
R
R
/C
)
B
B
DIGITAL LINK IN / OUT terminal
connection
Twisted pair cable transmitters such as the Panasonic
Digital Interface Box (ET-YFB100G) or the DIGITAL
LINK Switcher (ET-YFB200G) use twisted pair cables
to transmit inputted video and audio signals, and
these digital signals can be input to the Display via the
DIGITAL LINK terminal.
PC to control the unit
Example: Panasonic ET-YFB100G
PC
DVD Player
Note
●
Video equipment and connection cables are not
supplied with this unit.
●
When connecting with DIGITAL LINK, be sure to
configure each of the [Network settings] settings. (see
page 68)
For the cautions for DIGITAL LINK setting and
connection, see page 82.
●
Corresponding signal for DIGITAL LINK input is the
same as that of HDMI input. (see page 113)
Analogue signal is output as
Digital signal.
Advertisement
Table of Contents
