Power Management Settings - Panasonic TH-42LF8U Operating Instructions Manual

Power management settings

Set each item to reduce power consumption.
Power management settings
Power management mode
No signal power off
HDMI1 power management
HDMI2 power management
DIGITAL LINK power management
DVI-D power management
PC power management
Power save
■
Power management mode: On
The following fixed values are set to the menu of
power consumption reduction. Individual setting is not
available.
[No signal power off]: [Enable]
[HDMI1 power management]: [On]
[HDMI2 power management]: [On]
[DIGITAL LINK power management]*: [On]
[DVI-D power management]: [On]
[PC power management]: [On]
[Power save]: [On]
: LF80 series only
*
■
Power management mode: Custom
The menu of the power consumption reduction is
individually set. This setting is enabled when [Power
management mode] is set to [Custom].
[No signal power off]
When this is set to [Enable], the power supply of the
unit goes off automatically when there is no operation or
sync signal for about 10 minutes.
Note
●
With the USB input, the unit determines no signal is
present when the USB device is not connected.
[HDMI1 power management]
[HDMI2 power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 or so seconds at HDMI1 - HDMI2 input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected:
Power is turned on; the power indicator lights up
green.
50
English
Custom
Disable
Off
Off
Off
Off
Off
Off
[DIGITAL LINK power management] (LF80 series)
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 or so seconds at DIGITAL LINK input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected:
Power is turned on; the power indicator lights up
green.
[DVI-D power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 or so seconds at DVI-D input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected:
Power is turned on; the power indicator lights up
green.
[PC power management] (DPMS function)
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (HD/VD sync signals) are
detected for 60 or so seconds at PC input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (HD/VD sync signals) are
subsequently detected:
Power is turned on; the power indicator lights up
green.
Note
●
This function is effective when [Sync] in [Signal]
is set to [Auto] or [HV sync] and during normal
viewing and [Component/RGB-in select] is set to
[RGB]. (see page 46)
[Power save]
This function adjusts the brightness of the backlight to
reduce power consumption.
[Off]:
This function does not operate.
[On]:
Backlight brightness is reduced.