Table of Contents
Advertisement
Starting / ending Media Player
■
For Single Media Player
Start
1. Insert USB memory for Media Player.
Note
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
U S B
2. Run a USB memory contents check.
3. Change INPUT to [USB].
Ending
Change INPUT to other than [USB].
■
For Multi Media Player
Start
1. Connect several units with LAN cables.
(see page 92 "Example of setting up LAN connection
and IP address / Subnet mask")
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on each
Display.
4. Change INPUT for Slave to [USB].
5. Change INPUT for Master to [USB].
Ending
Change INPUT for Master to other than [USB].
USB terminal
USB memory
Resume Play function
After Media Player ends, the file to be resumed when
resuming playing varies depending on the setting of
[USB media player settings] - [Resume play].
When set to [On]:
The file played prior to the end of Media Player starts
playing from the beginning.
When set to [Off]:
Play starts from the beginning of the first file of the
scenario.
Note
●
The resume play function is retained until the unit is
turned off or the USB memory device is taken out.
93
English
Hide quick links:
Advertisement
Table of Contents
