Network Settings - Panasonic TH-42LF8U Operating Instructions Manual

Network settings

Set when networking with a computer.
[Network settings] submenu will be displayed.
LF8
Network settings
Network control
Display name
LAN setup
Network status
AMX D.D.
Crestron Connected™
Reset
LF80
Network settings
Serial control
Network control
Display name
LAN setup
Network status
DIGITAL LINK mode
DIGITAL LINK status
DIGITAL LINK menu
AMX D.D.
Crestron Connected™
Extron XTP
Reset
■
[Serial control] (LF80 series only)
Selects the RS232-C control terminal.
[SERIAL IN]:
Controls using the SERIAL IN terminal of the
display.
[DIGITAL LINK]:
Controls via the optional device that supports
DIGITAL LINK output (ET-YFB100G, ET-
YFB200G) and the DIGITAL LINK / LAN terminal.
54
English
Off
LF8-00
Off
Off
SERIAL IN
Off
LF80-00
Auto
Off
Off
Off
■
[Network control]
Set when controlling with the unit's LAN terminal.
[On]:
Controls via LAN using the LAN terminal of the
Display. The power indicator lights orange when
the power is turned off with the remote control
(standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
●
When using the LAN control function for "Using
Network Function" (page 71 - 78), set this function
to [On]. Even if [Off] is selected, the HDMI
communication via a twisted pair cable transmitter
is possible while the power is on.
■
[Display name]
The name of the Display that is shown on the network
can be changed.
■
[LAN setup]
Detailed network settings for the LAN established via
the LAN terminal of the Display or twisted pair cable
transmitter can be configured.
Select [LAN setup] with
LAN setup
Save
DHCP
IP address
192.168.
Subnet mask
255.255.255.
Gateway
192.168.
Port
MAC address
[DHCP], [IP address], [Subnet mask], [Gateway]
Press to set [On] / [Off] of [DHCP] and press
<ENTER>.
When [Off] is selected, IP address and other settings
can be set manually.
[DHCP]:
(DHCP client function)
[On]:
Obtains an IP address automatically when a
DHCP server exists in the network the Display is
going to be connected.
[Off]:
When a DHCP server does not exist in the
network the Display is going to be connected,
set [IP address], [Subnet mask] and [Gateway]
manually.
and press <ENTER>.
Off
0. 8
0
0. 1
1024
--:--:--:--:--:--