a.
stand
b.
back cover
c.
system-board shield
3.
Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory
module from its connector.
Installing the memory module
1.
Align the notch on the memory-card with the tab in the system-board connector.
2.
Press down on the memory module until the release tabs spring back to secure them in place.
3.
Install the:
a.
system-board shield
b.
back cover
c.
stand
4.
Follow the procedure in
Removing the intrusion switch
1.
Follow the procedure in
2.
Remove the:
a.
stand
b.
back cover
c.
VESA mount bracket
d.
system-board shield
3.
Perform the following instructions as shown in the illustration:
a. Disconnect the intrusion-switch cable from the connector on the system board [1].
b. Unthread the intrusion-switch cable from the retention clips on the computer [2].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
25