Installing the optical-drive assembly
1.
Tighten the screws to secure the bracket to the optical drive.
2.
Insert the optical-drive assembly into the drive slot, until it snaps in.
3.
Install the:
a.
back cover
b.
stand
4.
Follow the procedure in
Removing the system-board shield
1.
Follow the procedure in
2.
Remove the:
a.
stand
b.
back cover
3.
Perform the following steps as shown in the illustration:
a. Press the securing tab to release the system-board shield from the slots on the computer [1].
b. Slide the system-board shield away from the computer [2].
c. Lift the system-board shield from the computer [3].
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
15