Transmitter Controls; Safe Technology Flight Mode (Rtf); Flight Mode Selection (Bnf) - Blade NANO QX 3d Manual

Transmitter Controls

Flight mode
switch
Bind switch
H
G
F
When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing. The middle or neutral trim position
is heard as a middle tone in the pitch range of the sounds. The end of the control range is sounded by a series of beeps.
A B
Mode 2
Power Aileron (Left/Right) Eleva-
Elevator (Up/Down) tor Trim
LED/rate
indicator
EN
A
B
C
D
E
C D E F G
Aileron ON/OFF Rudder Throttle Rudder (Left/Right)
Trim Switch Trim Trim Throttle (Up/Down)
10
RTF
SAFE Technology Flight Modes – RTF
RTF
Trigger
The Nano QX 3D RTF model comes with the Blade MLP6DSM transmitter.
(bind switch)
This transmitter has a switch that lets the pilot change among 3 SAFE Technology flight modes.
IMPORTANT: Ensure the flight mode switch is in the desired position before flying.
• Beginner Mode (switch position 0).
Release the control sticks to neutral and the quadcopter will level itself.
• Intermediate Mode (switch position 1).
Release the control sticks to neutral and the quadcopter will level itself.
• Evo Mode (switch position 2). Only switch to this mode before takeoff. If switched to this mode in flight,
Dual rate
the quadcopter will only operate with switch position 1 options.
switch
Control Sensitivity – Press down on the right stick: transmitter LED flashes for Low, LED solid for High (default)
Transmitter Trigger Options
• Beginner Mode (0) Flip– Press the trigger for a 360 degree flip, then move the aileron or elevator stick
fully in the desired flip direction.
• Intermediate Mode (1) Invert– Press the trigger once, then move the aileron or elevator stick fully in the
desired invert direction. The quadcopter responds to controls the same as when it is not inverted.
• Evo Mode (2) Throttle Cut– Press the trigger to cut throttle, stopping the motors for advanced 3D maneuvers.
Flight Mode Selection – BNF
H
If you purchased a BNF Nano QX 3D, the channel 5 switch on your transmitter will select flight modes. See the table on the following
page for specific setup information.
1 2
0
11
EN