Charging The Flight Battery; Install The Gimbal (Ap Combo); Install The Transmitter Batteries (Rtf, Ap Combo) - Blade 350 QX3 Instruction Manual

Charging the Flight Battery

1a
2

Install the Gimbal (AP Combo)

Install the Transmitter Batteries (RTF, AP Combo)

1b
3
a
b
Charger Specifications
• Input Voltage: 10.5–15V DC
• Charge Current: 3.5A
1. Connect the AC power supply to the charger.
2. Connect the AC power supply to an AC power source.
The green LED blinks.
3. Connect the battery to the charger. The red LED
blinks, indicating charging. When the battery nears
full charge, the red and green LEDs blink, indicating
cell balancing.
4. Disconnect the battery when the green LED glows
solid.
Charger LED Codes
Green Blinking: Power connected
Red Blinking: Charging
Red & Green Blinking: Cells balancing
Green Solid: Charging complete
Red Solid: Error
batteries can result in a fire, personal injury and/or
property damage.
NOTICE: If using a battery other than the included
Li-Po battery, refer to your battery manufacturer's
instructions for charging.
• Slide the gimbal on the mount rails until it locks.
• Connect the wiring harness to the plug on the bottom
of the 350 QX3.
• To remove the gimbal, press the tab at the front of
the mount and slide the gimbal forward.
• Install 4 AA batteries in the transmitter as shown.
5
The Battery Charging Process
CAUTION: All instructions and warnings must
be followed exactly. Mishandling of Li-Po
EN