Maxcom MC6950 Quick Start Manual page 29

Press on handset :
x 2
x
or
x 2
x 3
or
x 2
x 4
or
Set the ringer volume
Enter in the menu and Select
1
Select RING VOL
Press MENU / OK and UP / DOWN to select the desired ringer volume. (a
total of 6 ringer
volume levels including OFF)
Note: The respective ringer volume will be played during your selection.
Press MENU / OK to confirm.
Dialling mode setting
You should normally leave the dialling mode at its default setting of TONE (also called DTMF)
unless the phone is connected to an old exchange that only recognises PULSE dialling.
Note: If PULSE dialling is set, you can press the * key to switch to TONE dialling for the rest of
that call.
Enter in the menu and Select
Select DIALMODE
Select TONE or PULSE
(The current setting is indicated by an asterisk to the right)
Press MENU / OK to confirm.
Touch R setting
You may need to change the recall (flash) time if your phone is connected to a PBX. The recall
time options are SHORT (100ms), MEDIUM (300ms) or LONG (600ms).
Enter in the menu and Select
Select FLASH
Select SHORT or
(The current setting is indicated by an asterisk to the right)
Press MENU / OK to confirm.
BS SET
BS SET
BS SET
MID or LONG