Table of Contents
Advertisement
Operations Manual
Release
Fig 16
Fig 17
Fig 18
©2004 General Binding Corporation
15mm Mounting
10mm Mounting
5mm Mounting
3mm Mounting
Low-Prs Laminating
Mid-Prs Laminating
(G)
High-Prs Laminating
H. IDLER BAR: (Figure 17) The idler bars, located near
each heat roller, are used to direct the film to the heat
roller nip.
I. CHILL IDLER: (Figure 17) Assist in the cooling process
of the web material as it exits the heat rollers.
To engage the chill idler, grip the chill idler handles located
on each side of the chill idler and lower to the web position
(1). To disengage the chill idler, move the chill idler to it's
rest position (2).
J. COOLING FANS: (Figure 17) Assist in the cooling
process by pushing unheated air onto the web
K. FILM SHAFT: (Figure 18) The film shaft holds the film
supply on the machine.
To remove the film shaft, lift up on the round end (1) of
the unwind/ rewind shaft then pull the hex end (2) of the
shaft out and away from the laminator.
L. CORE ADAPTORS: (Figure 18) Hold and lock the rolls
of film on the shafts to prevent side to side shifting.
M. LOWER SHAFT LOCK: (Figure 18) Secures the left
side of the lower shafts. To remove a shaft, turn the outer
dial (1) opening so it aligns with the inner u-channel (2)
opening and lift up and out.
N. UNWIND/ REWIND TENSION: (Figure 18) Used to
apply resistance to the film shaft.
To increase film shaft tension, turn the film shaft tension
knob clockwise. Counter clockwise will decrease film
shaft tension.
O. REWIND SHAFT: (Figure 19 on next page) The rewind
shaft holds the rewind tube on the machine.
P. REWIND TUBE: (Figure 19) The two rewind tubes
located at the front of the machine are used to rewind
release liners. The one located at the rear of the machine
is used to rewind the finished product.
Q. REWIND ADAPTORS: (Figure 19) Hold and lock the
rewind tube on the rewind shafts to prevent side to side
shifting.
T
44/64
ALON
CE
Page 21
Advertisement
Table of Contents
