Table of Contents
Advertisement
Operations Manual
©2004 General Binding Corporation
Fig 4
Installation
1. Shipping damage should be brought to the imme-
diate attention of the delivering carrier.
2. With assistance, carefully roll the laminator into posi-
tion over flat and even surfaces.
3. The laminator should be positioned to allow exiting film
to flow freely to the floor or a work table (Figure 4).
Accumulation of laminate immediately behind the lami-
nator as it exits the equipment may cause the film to
wrap around the pull rollers, resulting in a "jammed"
condition.
4. Avoid locating the laminator near sources of heat or
cold. Avoid locating the laminator in the direct path of
forced, heated or cooled air.
5. Once the laminator has been properly positioned,
lock the castors in place. Locking the castors prevent
the machine from rolling during set up, operation or
servicing.
6. The heaters must be installed by a GBC qualified
service technician. Refer to your Warranty section
for explanation of "Qualified".
7. Connect the attachment plug provided with the laminator
to a suitably grounded outlet. Avoid connecting other
equipment to the same branch circuit to which
the laminator is connected, as this may result in
nuisance tripping of circuit breakers or blowing
fuses.
T
44/64
ALON
CE
Page 15
Advertisement
Table of Contents
