Sony TRINITRON BVM-A20F1U Operation Manual page 81

For information about the PARALLEL REMOTE menu,
[D]
see " System Configuration – SYSTEM
CONFIGURATION Menu" on page 42.
To switch each function between on and off or between
enable and disable, change pin connections in the
following way.
ON or enabled: Short each pin and pin 9 together.
OFF or disabled: Leave each pin open.
f SERVICE terminal (male, D-sub 9-pin)
This connector is for use by service personnel only.
g NETWORK switch
Set to LAN for the network connections. Set to PEER TO
PEER when the monitor is connected directly to the LAN
(10/100) connector of the BKM-15R (1 to 1 connection).
h LAN (10/100) connector (10BASE-T/100BASE-TX)
Connect to the network by using a 10BASE-T/100BASE-
TX LAN cable (shield type, optional) or to the LAN (10/
100) connector of the BKM-15R. Or connect to the LAN
(10/100) connector of the BKM-15R by using the SMF-
700 or the cable supplied with the BKM-35H.
CAUTION
• When an optional LAN cable is connected, use a shield
type cable to prevent miss-operation due to noises. Also,
to directly connect the monitor to the LAN (10/100)
connector of the BKM-15R (NETWORK switch is set to
PEER TO PEER) (1 to 1 connection), use a straight
(shield type) cable.
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
Follow the instructions for this port.
• The connection speed may be affected by the network
system. This unit does not guarantee the communication
speed or quality of 10BASE-T/100BASE-TX.
i DC 5V OUT connector (female)
Supplies the DC power for the BKM-15R.
Connect to the DC 5V IN connector of the BKM-15R with
the SMF-700 or the cable supplied with the BKM-35H.
(male)
Plug the male
connector into
the monitor.
Note
Be sure to plug the male connector of the cable into the
DC 5V OUT connector on the monitor.
Location and Function of Parts
13