Advertisement
OPERATING GUIDELINES
IMPORTANT: Never allow temperature setting above 300 degrees Celsius
for pro-longed period. Temperature setting at lower temperature will
preserve heater life.
5.
The Timer can be adjusted by pushing the "+" and "-" buttons of
the Timer control buttons. ("9" from control panel guide).
6.
The Timer display ("8" from control panel guide) will show the
current set timer settings.
7.
Timer settings can only be adjusted during automated control
mode.
Note: The Set Temperature and Timer settings will automatically be saved
into the CPU memory once one complete cycle of the automated
procedure is finished.
4.
AUTOMATIC CONTROL
1.
Automatic or Manual Control can be selected by pressing the
SELECT button. ("10" from control panel guide).
2.
When the Green Lamp is lighted it means the system is currently
in Automatic control mode.
3.
If the Red Lamp is lighted the system is in manual control mode,
push the SELECT button to switch to automatic control mode.
4.
To initiate the automatic soldering procedure push both start
buttons simultaneously ("13,16" from control panel guide).
5.
The automatic soldering cycle:
The platform moves in
●
If platform is completely in, the hot bar soldering tool would
●
descend.
When the hot bar soldering tool has reached the platform count
●
down timer would commence.
With Count down completed, hot bar tool would move back up.
●
●
The platform slides out to original position.
6.
The automatic soldering cycle can be repeated by pressing both
start buttons again.
CAUTION: Improper usage can cause serious injury to personnel and/or damage
●
●
●
●
●
●
●
●
●
●
1.
2.
side of the unit. Mount both LCD monitors. Attach the 5 pin LCD moni-
tor connectors to the base of the upper control box and its other ends
to the LCD monitor.
3.
off the main valve at the air compressor. Switch on the air compressor
when gauge at the air compressor reaches 0.2 MPA turn on the main
valve.
4.
the main power source.
Note: In order for pneumatic system to function, Compressed air should
6 6 6 6
be fed into system.
SAFETY PRECAUTIONS
to equipment. For personnel safety, please follow these precautions:
Check each component after opening the package to make sure everything
is in good condition. Do not use item if visible damage is seen, report the
issue to your vendor.
Power off unit and unplug the device when moving the device from one loca-
tion to another.
Do not subject the main unit to physical shock
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
Always connect power to a grounded receptacle.
Tip temperature may reach as high as 350°C when switched ON.
Disconnect from power source if the unit will not be used for a long periods.
Use only genuine replacement parts.
Soldering process produces smoke — use on well ventilated place.
Do not try to alter or repair unit, bring to qualified service center for repairs.
Never insert body parts between the paths of the moving platforms.
Initial Setup
Place unit on top of a flat and stable work table.
LCD Monitor — Pull out the LCD Monitor mounting bracket on each
Air compressor** — Attach Air compressor tube to the unit. Turn
Make sure power switch is turned OFF before plugging the device to
** Air compressor is sold separately.
3 3 3 3
Advertisement
