CAUTION
Screw the jack back into the starting position before storing in the box with
■
the vehicle tool kit.
Ensure that the vehicle tool kit is safely secured in the luggage compart-
■
ment.
Ensure that the box is always secured with the strap.
■
Note
The declaration of conformity is included with the jack or the log folder.
Changing a wheel
Introduction
This chapter contains information on the following subjects:
Preparation
For your own safety and the safety of your passengers, the following instruc-
tions must be observed before carrying out a wheel change on the road.
Switch on the hazard warning light.
Place the warning triangle at the prescribed distance.
Park the vehicle as far away as possible from flowing traffic.
Choose a location with a flat, solid surface.
Have all the occupants get out. The passengers should not stand on the
road (instead they should remain behind a crash barrier, for instance) while
the wheel is being changed.
Preparation
Before changing the wheel, the following work must be carried out.
›
Switch off the engine.
›
For vehicles with manual transmission select 1st gear.
›
On vehicles with automatic transmission, place the selector lever in the P
position.
›
The parking brake switch.
›
Uncouple any trailers.
Removing/stowing the wheel
213
213
213
The wheel is located in a well under the floor covering in the boot and is fixed
in place with special bolt
214
214
Take out the wheel
›
215
Open the boot lid.
›
215
Raise the floor covering in the boot
›
216
Loosen the retaining belt and take out the box with the tool kit.
›
Remove locking
in the direction of arrow
216
A
›
Unscrew nut
in the direction of arrow
B
›
Remove the wheel.
Store wheel away
›
Place the wheel into the wheel well with the wheel rim pointing downward.
›
Pull the fixing band through the opposite holes in the wheel rim.
›
Screw in nut
in the opposite direction to arrow
B
›
Insert locking
in the opposite direction to which arrow
A
›
Replace the box with the tool kit into the emergency or spare wheel and se-
cure it with the tape.
›
Fold back the floor covering in the boot
›
Shut the boot lid.
Full wheel trim
Before removing the wheel bolts, remove the full wheel trim.
Take out the wheel
» Fig.
217.
B
» page
103.
217.
1
.
2
» Fig.
2
» page
107.
Emergency equipment, and self-help
217.
is pointing.
1
213