Turn Signal And Main Beam - Skoda Octavia Owner's Manual

Activating/deactivating function on vehicles with Infotainment
The function can be disabled/enabled in the Infotainment
Infotainment, chapter CAR - vehicle settings.
Deactivating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the indicator / main beam lever towards the steering wheel, push down
and hold in this position.
›
Switch on the ignition.
›
Hold the lever in this position for min. 3 seconds after switching on the igni-
tion.
The deactivation of the function is confirmed by an audible signal.
Activating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the indicator / main beam lever towards the steering wheel, push up and
hold in this position.
›
Switch on the ignition.
›
Hold the lever in this position for min. 3 seconds after switching on the igni-
tion.
The activation of the function is confirmed by an audible signal.
WARNING
Always switch on the low beam when visibility is poor.

Turn signal and main beam

» Owner´s Manual
Fig. 55
Operating lever: Turn signal and
main beam operation

Read and observe on page 67 first.
Lever positions » Fig. 55
When the right turn signal light is switched on, the warning light flashes in
A
the instrument cluster

When the left turn signal light is switched on, the warning light flashes in
B
the instrument cluster

Depending on equipment (spring-tensioned position):
C
▶
Switch on main beam – the warning light illuminates in the instrument
cluster

▶
Switch on main beam assistant
Depending on equipment (spring-tensioned position):
D
▶
Switch on main beam or headlight flasher (spring-loaded position)
▶
Switch off main beam assistant/switch on headlight flasher (spring-ten-
sioned position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
"Convenience turn signal"
When the control lever is lightly pressed to the pressure point
the respective turn-signal lamp flashes three times.
If during the "comfort flashing" the operating lever in the opposite side is
pressed, then the blinking stops.
The "Lane change flash" can be activated/deactivated in the Infotainment
» Owner´s Manual Infotainment, chapter CAR - vehicle settings.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.
» page 71
or
A B
Lights and visibility
then
69