Skoda Octavia Owner's Manual page 170

Key – Version 1
12
Key – Version 2
13
Note
If you lose the key, please get in touch with a specialist garage.
Adjusting the ready position
Fig. 186 Gear 1 Step: Key Version 1 / key Version 2

Read and observe and
The ball rod must be set to the ready position prior to installation
Correctly adjusted ready position.
If it is not in the ready position, then it must be set to the ready position as
follows.
Gear 1 Step - applies to the key version 1
›
Remove the cap from the lock
›
Insert key into the lock so that the green marking is pointing upwards.
A
168
Driving
Fig. 187
Step 2: Both key versions
on page 167 first.
›
Turn key in the direction of arrow
A
upwards » Fig.
Gear 1 Step - applies to the key version 2
›
Remove the cap from the lock
›
Insert key
B
›
Turn the key in the direction of arrow
shows up » Fig.
Gear 2 Step - applies to both key versions
›
Grip the tow bar below the protective cap.
›
Push release pin
ously push operating lever
» Fig. 187.
Operating lever
Correctly adjusted ready position
Fig. 188 Ready position: Key Version 1 / key Version 2 / position of the
lever and the release bolt with two key versions

Read and observe
Correctly adjusted standby position
» page 168,
Applies to key version 1 - the red marking on key

Applies to key version 2 - the eye of the key

Operating lever

The trigger pin

The ball bar is thus set ready for installation.
so that the red marking is pointing
1
186.
into the lock so that the eye of the key is pointing downwards.
so that the conclusions release
B 2
186.
in the direction of arrow
C 3
in the direction of arrow
D
remains locked in this position.
D
and on page 167 first.
» Fig. 188
is locked in the lower position.
C
can be moved.
D
to the stop, and simultane-
to the stop
4
is pointing upwards.
A
is pointing upwards.
B
