Skoda Octavia Owner's Manual page 54

Disconnection
The connection can be switched off in one of the following ways.
›
Switch off the ignition for longer than 5 seconds (for vehicles with a starter
button, switch off the engine and open the driver's door).
›
End the connection in the SmartGate application.
›
Switch off the Wi-Fi on the connected communication device.
Automatic connection
If the communication device once had a connection with SmartGate, then the
connection is automatically restored after the ignition is started.
SmartGate web interface

Read and observe and
SmartGate parameters can be set in the SmartGate web interface.
The following address must be entered via Wi-Fi in the web browser of the
connected communication device.
HTTP://192.168.123.1
The setting changes are only effective after pressing the "Save" button and
then the "Reboot" button.
Password/PIN code change

Read and observe and
The password for the Wi-Fi connection preset by the factory is the complete
vehicle identification number (upper case); the PIN code for the Wi-Fi Direct
connection preset by the factory is the last 6 digits of the vehicle identification
number.
After changing the password/PIN, the connection to SmartGate must be re-es-
tablished on the communication device to be connected using the new pass-
word or new PIN code.
If the password/PIN code is still set to the preset factory password/PIN code,
you are requested to change the password/PIN code after starting the ŠKODA
application. Without changing the password/PIN code, you are unable to use
the application.
1)
If the "Reboot" interface is not displayed, you must manually restore the web browser display.
52
Using the system
on page 50 first.
on page 50 first.
Changing the password for the Wi-Fi connection
›
Open the SmartGate web interface.
›
In the "WPA / WPA2 key:" menu item, enter the new password (8 to 63 al-
phanumeric characters and special characters, small and capital letters).
›
Confirm the password change by tapping on the "Save" interface.
›
Restart SmartGate by tapping on the "Reboot"
Changing the PIN code for the Wi-Fi Direct connection
›
Open the SmartGate web interface.
›
In the "WiFi Direct PIN:" menu item, enter the new PIN code (6 digits).
›
Confirm the PIN code change by tapping on the "Save" interface.
›
Restart SmartGate by tapping on the "Reboot"
Note
If you have forgotten your password for the connection to SmartGate,
SmartGate must be reset to factory settings in a specialised workshop.
interface.
1)
interface.
1)