RAM 1500 Owner's Manual page 515

Hide thumbs Also See for 1500:
Table of Contents

Advertisement

button once from the NRH while the vehicle speed is
below 33 mph (53 km/h). Once the vehicle speed goes
below 15 mph (24 km/h) the vehicle height will begin
to lower. If the vehicle speed remains between 15 mph
(24 km/h) and 25 mph (40 km/h) for greater than 60
seconds, or the vehicle speed exceeds 25 mph
(40 km/h) the Entry/Exit change will be cancelled. To
return to Normal Height Mode, push the "Up" button
once while in Entry/Exit or drive the vehicle over
15 mph (24 km/h). Entry/Exit mode may not be
available due to vehicle payload, an EVIC/DID mes-
sage will be displayed when this occurs. Refer to
"Electronic Vehicle Information Center (EVIC) or
Driver Information Display (DID)" in "Understanding
Your Instrument Panel" for further information.
NOTE: Entry/Exit mode may be achieved using your
key fob for easier entry/loading. Refer to "A Word About
Your Keys" in "Things To Know Before Starting Your
Vehicle" for further information.
• When in ENTRY/EXIT setting, be aware of your
surroundings, you may not have the clearance re-
quired for certain areas and vehicle damage may
occur.
The system requires that the ignition be in ON/RUN
position or the engine running for all user requested
changes. When lowering the vehicle all of the doors,
must be closed. If a door is opened at any time while the
vehicle is lowering the change will not be completed
until the open door(s) is closed.
This system uses a lifting and lowering pattern which
keeps the headlights from incorrectly shining into on-
coming traffic. When raising the vehicle, the rear of the
vehicle will move up first and then the front. When
lowering the vehicle, the front will move down first and
then the rear.
STARTING AND OPERATING 513
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ram 3500Ram 2500

Table of Contents