RAM 1500 Owner's Manual page 216

214 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
1. Turn the ignition switch to the ON/RUN position.
For vehicle's equipped with Keyless Enter-N-Go™, place
the ignition in the RUN position with the Engine ON.
2. Place the hand - held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink® button you wish to
program.
3. Push and hold the Homelink® button you want to
program while you push and hold the hand - held
transmitter button.
4. Continue to hold both buttons until the EVIC/DID
display changes from "CHANNEL # TRAINING" to
"CHANNEL # TRAINED," then release both buttons.
NOTE:
• It may take up to 30 seconds or longer in some cases
for the channel to train.
• If the EVIC/DID displays "DID NOT TRAIN" repeat
from Step 2.
5. At the garage door opener motor (in the garage),
locate the "LEARN" or "TRAINING" button. This can
usually be found where the hanging antenna wire is