Canadian/Gate Operator Programming - RAM 1500 Owner's Manual

3. Without releasing the button proceed with "Program-
ming A Non-Rolling Code" step 2 and follow all
remaining steps.

Canadian/Gate Operator Programming

For programming transmitters in Canada/United States
that require the transmitter signals to "time-out" after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink®
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
1. Turn the ignition switch to the ON/RUN position.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 217
For vehicle's equipped with Keyless Enter-N-Go™, place
the ignition in the RUN position with the Engine ON.
2. Place the hand - held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink® button you wish to
program.
3. Push and hold the Homelink® button while you push
and release ("cycle"), your hand - held transmitter
every two seconds.
4. Continue to hold both buttons until the EVIC/DID
display changes from "CHANNEL # TRAINING" to
"CHANNEL # TRAINED," then release both buttons.
NOTE:
• It may take up to 30 seconds or longer in some cases
for the channel to train.
• If the EVIC/DID displays "DID NOT TRAIN" repeat
from Step 2.
3