Setup - Imperx LYNX Series Hardware User Manual

5.2

Setup

1. Make sure that LYNX GigE Application and LYNX GigE high performance
driver are properly installed. For more information on GigE software and
driver installation, refer to Appendix E of this manual.
2. Make sure that camera is powered on (the green LED on the back is lit) and
that the cable is connected.
3. Click on Detect button in "Device Tab". The device finder window shown in
figure 5.2 will appear.
4. Select the high performance driver and click OK.
5. A new window with the IP address will appear. Click OK, and the window
will close. Click OK in the main device finder window.
6. Click on "Select Camera" and select the connected camera.
7. Click on Acquisition tab and click "Start" in Acquisition Control. You should
see an image. To stop the image acquisition – click on the "Stop" button.
8. To access the camera features, click on the "LYNX Configurator" tab and
select the settings you wish to modify.
LYNX Hardware User's Manual
171 of 216