Troubleshooting - Silvercrest 4160 User Manual

trouBleshooting

Warning!
Immediately switch off the appliance in case of operational faults and
electrical failures. Unplug it from the socket-outlet. Wait for the appli-
ance to cool down.
PROBLEmS
On light off
No steam comes
out of the nozzle
unexpected incre-
ase of the noise
level of the pump
Water leakage
from the nozzle
CAuSES
Not plugged in
Steam dispensing button
not pressed
The appliance is not
ready for use
Water shortage in tank.
Incorrect insertion of the
tank in its seat.
The steam exit holes may
be blocked by limescale.
Water shortage in tank. Turn off the appliance and fill the water
Incorrect insertion of the
tank in its seat.
Possible condensation
residue in the steam duct
SOLuTIONS
Check that the appliance is properly
plugged in. Check that there is current
on the power supply line. Try to plug the
appliance into another socket-outlet. If the
problem continues, contact an Authorised
Service Centre.
Press the steam dispensing button all the
way down
Press the steam dispensing button for thirty
(30) seconds or until you hear the noise of
the pump. Wait for the steam to come out.
Fill the tank with fresh water by positioning
it directly under the tap up to the lower rim
of threading.
Remove the tank and put it back in, making
sure it is in the right position.
Contact an Authorised Service Centre.
tank.
Remove the tank and put it back in, making
sure it is in the right position.
Press the steam dispensing button until you
see steam coming out. Position a soft cloth
so as to not dampen the floor. If water con-
tinues to come out, turn off the appliance.
Wait at least 5 minutes so that the steam
head and cloth cool down. Try again.
GB / IE
it
GB / IE 11