Transport And Unpacking; Panel Mounting - Advantech TPC-1582H User Manual

Hide thumbs Also See for TPC-1582H:

Table of Contents

2.1

Transport and Unpacking

When accepting a delivery, please check the packaging for visible transport damage

and check the delivery for completeness by comparing it with your order. If you notice

any shipping damage or inconsistencies between the contents and your order,

please inform the responsible delivery service immediately.

During transport, the TPC should be protected from excessive mechanical stress. If

the TPC is transported or stored without packaging, shocks, vibrations, pressure and

moisture may impact the unprotected unit. A damaged packaging indicates that

ambient conditions have already had a massive impact on the device. Therefore,

please use the original packaging during transportation and storage.

If the TPC is transported in cold weather or is exposed to extreme variations in tem-

perature, make sure that moisture (condensation) does not build up on or inside the

HMI device. Moisture can result in short-circuits in electrical circuits and damage the

device. To avoid that, please store the TPC in a dry place and bring the TPC to room

temperature before starting it up. If condensation occurs, a delay time of approxi-

mately 12 hours must be allowed to make sure the TPC is completely dry before the

TPC is switched on.

2.2

Position the TPC against the panel.

Insert the holding clip into the side of the TPC.

TPC-1582H/TPC-1782H User Manual

Table of Contents

Tpc-1782h