LanParty JR 790gx m2rs User Manual page 89

DRAM RAS# Precharge
This field is used to select the idle clocks after issuing a precharge
command to the DRAM.
DRAM RAS# to CAS# Delay
This field is used to select the latency between the DRAM active
command and the read/write command. The options are 2 and 3.
Bank to Bank Cmd (TRRD)
The options are Auto, 2 CLK to 5 CLK.
TRC
Row-Cycle delay. Set the "System Performance" field to Optimal if
you want to use the delay time recommended by the DIMM manu-
facturer.
TRTP
The options are Auto, 2CLK - 4CLK and 3CLK - 5CLK.
Write Recovery (TWR)
This field is used to select the write recovery time when the DRAM
safely registers the last write data. This is the time from the last write
data to precharge.
Write-Read Command (TWTR)
The options are Auto, 1 CLK, 2 CLK and 3 CLK.
TRFC 0 to TRFC 3
These fields are used to select the auto refresh cycle time.
Trdrd
The options are Auto, 2 CLK, 3 CLK, 4 CLK and 5 CLK.
TrwtT0
The options are Auto, 3 CLK to 9 CLK.
3
BIOS Setup
8 9