Table of Contents
Advertisement
Registering with ScanNCutCanvas for Your Machine
After you have registered your machine with
ScanNCutCanvas
(http://ScanNCutCanvas.Brother.com/), they will be
able to communicate via a wireless network
connection to transfer data back and forth.
If setup is not completed correctly and an error
message appears, see "Error codes/Error messages"
on page 11.
Note
• A computer or tablet that is connected to the
network and can run ScanNCutCanvas is
required.
• Before continuing with this procedure, setup for
the connection between your machine and
wireless network must be completed. If your
machine is not connected to the network, first
follow the procedure in "Setting Up the Wireless
Network Connection" on page 3.
After setting up the wireless network, one of the
following screens will appear.
Memo
• If you stopped the procedure after setting up
the wireless network, touch the "Register" key
beside "ScanNCut Online" on page 7 of the
settings screen to start again with registering
your machine with ScanNCutCanvas. The same
screen that appeared immediately after setting
up the wireless network will be displayed.
■ If the following screen appears:
Touch the "Next" key, and then continue with
"Registering Your Machine with ScanNCutCanvas" on
page 8.
■ If the following screen appears:
Touch the "Next" key, and then continue with
"Activating Your Machine (Only on Machines
Requesting Activation)" on page 7.
Activating Your Machine (Only on
Machines Requesting Activation)
You will have to enter the activation code written on
the "ScanNCut Online Activation Card" for your
machine.
a
Prepare the "ScanNCut Online Activation
Card" and a coin.
Note
• Depending on the model, the "ScanNCut Online
Activation Card" may not be provided with your
machine. In that case, it must be purchased
separately.
7
Advertisement
Table of Contents
