Setting Up the Wireless Network Connection
The first step of the setup is to connect your machine to a wireless network.
If a connection is not established correctly and an error message appears, see "Error codes/Error messages" on
Activating the Wireless Network
With your machine, press
panel to display the settings screen.
Display page 6, and then touch
The network settings screen appears.
Select "ON" for "WLAN Enable".
Your machine will begin to emit the wireless
• "WLAN Enable" can also be set to "ON" by
touching the "Yes" key when the following
message appeared in the "Setup Wizard".
Setting Up the Wireless Network
A connection to the wireless network can be
in the operation
established using either the wizard (recommended)
or an alternative method.
■ Requirements for the wireless network
■ Using the Wizard on Your Machine
The wireless network connection complies with IEEE
802.11 n/g/b standards and uses the 2.4 GHz frequency.
• A wireless network cannot be set up with WPA/
WPA2 Enterprise. For the authentication
methods your machine supports, see "Err-03"
on page 12.
The SSID and Network Key for your wireless
access point/router are necessary to connect
your machine to the wireless network. The
Network Key may also be described as the
Password, Security Key or Encryption Key.
Find this information and note it first.
• If you do not know this information (SSID and
Network Key), you cannot continue the wireless
• How can I find this information?
1) You should see the documentation provided
with your wireless access point/router.
2) The default SSID could be the
manufacturer's name or the model name.
3) If you do not know the security information,
please consult the router manufacturer, your
system administrator, or internet provider.
Network Key (Password)