Checking The Wireless Network Setup/Status - Brother 891-Z02 Setup Manual

Note
• If a connection was not successfully
established:
- If the message "Wrong Network Key: Err-04"
appeared, the Network Key (Password) may
have been entered incorrectly. Touch the
"OK" key, and then repeat the procedure
b
from step
Machine (Recommended)" on page 3.
- For details on other causes, see "Error
codes/Error messages" on page 11.
• While connected, the strength of the signal is
indicated by the blue icon
left corner of screens such as the pattern
category selection screen.
: Strong signal
: Medium signal
: Weak signal
Memo
• After your wireless network has been set up,
your machine will connect to the wireless
network each time the machine is turned on.
However, "WLAN Enable" in the network
settings screen must remain set to "ON".
■ Setting Up the Wireless Network Using a
Computer
The wireless network can be set up using the dedicated
application "WLAN Assistant Wizard" (WAW).
Download the application from
http://solutions.brother.com/snc2waw, and then follow
the instructions that appear in the computer screen in
order to complete the setup.
When instructions to set up your machine appear, touch
beside "WAW (WLAN Assistant Wizard)" in the
network settings screen of your machine to perform the
setup.
After a connection is established, touch the "Next" key,
and then continue with "Registering with
ScanNCutCanvas for Your Machine" on page 7.
of "Using the Wizard on Your
in the upper-
Checking the Wireless Network Setup/
Status
Check this information when a connection cannot be
established with the wireless network.
a
In the network settings screen, touch
beside "WLAN Status".
The wireless network connection status, protocol,
signal strength and SSID are displayed.
a
b
c
d
a Displays the connection status.
Touch to display details in a separate
screen.
When "Active (xxx)" is indicated:
The machine is connected to a wireless
network. The characters within the parentheses
indicate the protocol of the wireless network
being used.
When "Connection Fail: Err-xx" is indicated:
The machine failed to establish a connection.
"Err-xx" indicates the error number. See "Error
codes/Error messages" on page 11.
b Displays the wireless signal strength,
communication speed and channel being used.
c Displays the SSID.
d Displays the communication mode. The
communication mode is fixed to the
infrastructure mode.
5