Problem Solution; Maintenance - Worx WX156 Safety And Operating Manual

your battery pack by operating your drill, then
remove the battery pack from the drill housing
and cover the battery pack connections with
heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt
to open or remove any of the components.
11. oveRloAD PRotectIoN
When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately
and allow cooling for approx. 30 seconds at
the highest no-load speed.
12. teMPeRAtURe DePeNDeNt
oveRloAD PRotectIoN
When using as intended for the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C is exceeded, the
electronic control switches off the power
tool until the temperature is in the optimum
temperature range again.
13. PRotectIoN AGAINSt DeeP
DIScHARGING
The Li-Ion battery is protected against deep
discharging by the "Discharging Protection
System" . When the battery is empty,
the machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.

PRObLEM SOLUTION

1. WHy DoeS tHe DRIll Not tURN oN
WHeN yoU PReSS tHe SWItcH?
The forward/reverse rotation control, which is
on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will
start to rotate.
2. tHe DRIll StoPS BefoRe tHe
ScReW IS coMPletely tIGHteNeD.
WHy?
Verify the torque position of the torque
adjusting ring, you can find the torque-
adjusting ring between the chuck and the drill
body. Position 1 is the lowest torque (screw
Lithium-Ion cordless
drill/driver
driving force) and position 15 is the highest
torque (screw driving force). Position
drill operation. Regulate the torque adjusting
ring to a higher position to reach the best
result.
3. ReASoNS foR DIffeReNt BAtteRy
PAck WoRkING tIMeS
Charging time problems, as above, and
having not used a battery pack for a prolonged
time will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0 C and above 45
O
performance.

MAINTENANcE

Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
WX156 WX156.1
WX166 WX166.1 WX166.2
is for
C as this will affect
O
11