Switch Lock - Worx WX156 Safety And Operating Manual

2. SWItcH lock

The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the rotation control in the center position.
3. ReveRSIBle (See fig. c1, c2)
For drilling and screw driving use forward rotation
marked " " (lever is moved to the left). Only use
reverse rotation marked "
right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction of
rotation when the chuck is rotating, wait
until it has stopped!
4. tWo-SPeeD GeAR coNtRol
(See fig. D)
The drill has a two-speed gear control designed for
drilling or driving at LO (mark is 1) or HI (mark is 2)
speeds. A slide switch is located on top of the drill to
select either LO or HI speed. When using the drill in the
LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the
drill in the HI speed range, the speed will increase and
the drill will have less power and torque.
Gear I
Low speed range: For screwdriving or working with
large drilling diameter.
Gear II
High speed range: For working with small drilling
diameter.
WARNING: to prevent gear damage, always
allow the chuck to come to a complete stop
before changing the direction of rotation or the
two-speed gear control.
5. cHUck ADjUStMeNt (See fig. e)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws. Finally,
firmly rotate the front chuck section in the opposite
directions. Your drill bit is now clamped in the chuck.
6. toRqUe ADjUStMeNt (See fig. f)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the torque
adjustment ring is set on a higher setting. The torque is
less when the torque adjustment ring is set on a lower
setting.
Lithium-Ion cordless
drill/driver
" (lever is moved to the
A1
A2
B
WX166 WX166.1 WX166.2
C1
C2
D
E
WX156 WX156.1
F
G
9