Push Power Switch To 'On' Power - CMA Dishmachines L-1C Quick Setup Instructions

Model L-1C
Quick Setup Instructions
WARNING: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
NOTE: WATER AND CHEMICALS
TO THIS DISHWASHER MUST BE
PROGRAMMED BY A QUALIFIED
CHEMICAL SPECIALIST.
STEP
5
Push power switch to "ON" power.
STEP
6
Press and Hold down "SANI", "DETERGENT"and "RINSE"
switches to prime chemicals. This step must be repeated each
time chemical containers are changed.
STEP
7
Hold down "FILL" Switch for approximately 10 - 15 seconds to allow water to flow into the dishwasher.
Water should reach "FILL LINE" which is located inside at the back of the wash tank.
of timer assembly has to be adjusted to maintain the same water level during the cycle.
5
POWER
CYCLE LIGHT
6
DETERGENT
6
SANITIZER
6
RINSE
8
START
7
DRAIN / FILL
THERMOMETER
STEP
8
Close the door, then press start switch.
TO
OPERATE
PERISTALTIC
MACHINE
PUMP
SET DELIMER
SWITCH TO
NORMAL
TIMER
FILL LINE
NOTE:
The 4th cam
800-854-6417
HOT
NEUTRAL
GROUND
DO NOT USE POWER
CORD OR GFI OUTLET.
5-2015