Preparing To Install - BESAFE iZi Kid i-Size User Manual

Preparing to install

Crucial parts
1. Adjustable head rest
2. Shoulder straps (2x)
3. Harness buckle
4. Body hugger
5. Front brace
6. Central adjuster
7. Reclining lever
8. Ratchet for front brace
9. Cap ISOfix connector (2x)
10. Switch for ISOfix connectors (2x)
11. Floor support
12. Height adjuster floor support
13. Floor support height indicator
14. Release handle head rest
15. Floor support position indicator
16. ISOfix car anchorage (2x)
17. ISOfix insertion clips (2x) (bottom side)
18. ISOfix connectors (2x)
19. ISOfix indicators (2x)
20. ISOfix release button (2x)
Rearward-facing: ISOfix installation
! It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
1. The seat can only be installed rearfacing in
vehicles equipped with ISOfix anchorage points.
2. When mounting in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
3. When mounting in the front seat of the vehicle, adjust the
back rest into an upright position.
4. Positioned in the front seat of the vehicle, you should
position the seat against the dashboard.
10
5. If it's not possible to position the seat against the dashboard,
position the seat as far as possible from the dashboard.
6. Find the ISOfix anchorage points in the vehicle. (21)
7. If your vehicle is not equipped with ISOfix insertion clips insert
these to make installation easier. (22)
8. You can find the ISOfix insertion clips under the base of the
seat or delivered separately with the seat.
9. Install the front brace by sliding the two pins into the oval tube
under the front side of the seat. Move the front brace inwards
with the ratchet. The ratchet is used to adjust the front brace in
both directions. Slide the switch on the ratchet up or down to
change direction. (23)
10. Pull both ISOfix connectors as far out as possible, by pushing
the grey buttons on top of the base. (24)
11. Remove the caps from the ISOfix connectors by pressing down
the ISOfix release buttons. (25)
12. Click the installation clips on the ISOfix connectors. (26)
13. Fold down the floor support before you install the seat in your
vehicle. (27)
14. Place the seat sideways into the car with the front brace
towards you.
15. Turn the seat into the right position (with the front brace
against the back rest).
16. Click the ISOfix connectors in the ISOfix anchorage of the
vehicle. (28)
17. Remove the installation clips.
18. Make sure that all indicators on both sides are green. (29)
19. Push the seat towards the backrest of vehicle seat till the
frontbrace touches the backrest; the isofix arms slide in and will
click into a new position. (30)
20. Move the front brace outwards with the ratchet. Continue
tightening until the brace is pressed well into the back rest of
the vehicle seat. (31)
21. Remove the cap around the floor support. An alarm sound will
start and stop when the seat is installed correctly with the floor
11