Changing Edid Mode - Octava HDHC44MX-V1.3 Installation Manual

Changing EDID mode:

It is recommended to keep the EDID in the factory default MODE1. If
necessary, you may set to different EDID mode by following these
instructions.
Step
1 Set the Smart Scan
switch to OFF
2 Disconnect all sources
and display from Matrix
3 Set the Progam/Lock
switch #4 to "program
mode" (down)
4 Set the EDID to the mode
desired. (MODE 2
shown.)
5 Reset Power to the
Matrix by disconnecting
the power and
reconnecting power.
6 The LED will now
indicate the EDID Mode
that you will
program.(mode 2 shown)
Action
See page 8 for
other EDID modes
1= mode 1
2= mode 2
3= mode 3
4= mode 4
10
Notes
flashed