BENETEAU OCEANIS 58 Owner's Manual page 117

G :
ENERAL POINTS
The air-conditioning cools the air temperature inside the boat (only when the boat is floating in water).
The cooling circuit consists of one or more compressors that operate independently. A compressor is called
"reversible" because it can heat the boat if the sea water temperature exceeds 10°C.
In winter, you can programme the dehumidifier function on the airconditioning controls.
The refrigeration compressors are made by one or two seawater pumps. These pumps are powered by 220V or 110V
and are guided by one or two relay boxes.
Sea water is evacuated through a through-hull fitting equipped with a valve, located above the waterline.
Each compressor has its own through-hull evacuation fitting. It is advisable to check the flow of water visually once the
air conditioning starts running.
O :
PERATION
Before starting the engine::
- Open the raw water intake valves and evacuation valves.
- Use the switch on the chart table to select the power source (shore power or generator).
If using shore power: plug into the shore power socket ;
If using the generator: before turning on the air conditioning, leave the generator running for about 3 minutes.
The air conditioning is running:
- Switch the circuit breakers 220V ,from the air conditioning,ON.
- Select the temperature of each compressor using the control units.
W S :
INTER TORAGE
Protection of sea water system: drain the whole sea water system.
Electrical equipment
A
IR CONDITIONING
9
113
W
ARNING
-Refer to the apparatus instructions for
use and maintenance.
-Never start the generator when the
climate function is already on.
-Always turn off the air conditioning before
turning off the generator.
-Regularly check and clean the sea water
filter placed on the sea water intake
through-hull fitting.
-Clean the air filter (located in the
compressor) regularly for maximum
performance of the installation.