Security Menu - Getac F110 User Manual

Security Menu

The Security menu contains the security settings, which safeguard your
system against unauthorized use.
NOTE:
You can set the user password only when the supervisor password has

been set.
If both the supervisor and user passwords are set, you can enter any of

them for starting up the system and/or entering BIOS Setup. However,
the user password only allows you to view/change the settings of certain
items.
A password setting is applied right after it is confirmed. To cancel a

password, leave the password empty by pressing the Enter key.
Set Supervisor/User Password sets the supervisor/user password. You can

set the supervisor/user password to be required for starting up the
system and/or entering BIOS Setup.
Password on Boot allows you to enable or disable the entering of

password for booting up your system. (This item appears only on
Windows 7 models.)
Set HDD 0 User Password sets the password for locking the Primary

Master hard disk drive. After setting a password, the hard disk drive can
only be unlocked by the password no matter where it is installed.
TPM Setup Menu

TPM Support enables or disables TPM (Trusted Platform Module) support.
TPM (Trusted Platform Module) is a component on your computer's
mainboard that is specifically designed to enhance platform security by
providing a protected space for key operations and other security critical
tasks.
Change TPM Status allows you to select between
Enable and Activate Disable and Deactivate
, and
46
No Change Clear
,
.
,