Out Of Balance Recovery Routine - Fisher & Paykel WashSmart Installation Instructions And User Manual

Out of balance recovery routine

When your washer is spinning it can sense if the wash load is out of balance. If an out of balance
load is detected, the machine will stop and re-try spinning one more time. If it still senses an
unbalanced load there are two options the machine can take.
Automatic recovery OFF (the default setting)
Your washer will stop, beep, and show "out-oF-bAL" in three phases on the display screen. You
must redistribute the load more evenly yourself. Use this option if you wish to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with water and
agitate to redistribute the load before trying to spin up again.
To change the out of balance recovery option:
Enter Option Adjustment mode (refer to page 32).
1
Select the HEAVY cycle.
2
Touch the MORE
3
Fig.36 Changing the out of balance recovery routine
End of cycle beeps
The beeps signalling the end of the cycle can be increased or decreased. The default setting is
5 beeps.
To modify the number of beeps sounding at the end of the cycle:
Enter Option Adjustment mode (refer to page 32).
1
Select the EASY IRON cycle.
2
Touch the MORE
3
of the cycle.
Fig.37 Modifying the number of beeps to signal the end of the cycle
button to turn AUTOMATIC RECOVERY on or off.
button to increase the number of beeps or for no beeps to sound at the end
Changing pre-set options
US
35
CA