Servicing Schedule - IDEAL VANGUARD L 170 Installation And Servicing

40 SERVIcING ScHEDuLE

To ensure the continued safe and efficient operation of the
appliance it is recommended that it is checked at regular
intervals and serviced as necessary. The frequency of servicing
will depend upon the installation condition and usage but should
be carried out at least annually.
Ideal does not accept any liability resulting from the use of
unauthorised parts or the repair and servicing of appliances not
carried out in accordance with the Company's recommendations
and specifications.
1. Light the boiler and carry out function checks, noting any
operational faults.
2. Run the boiler for 10 minutes and then check the burner
rate.
3. Refer to the commissioning report or log book for the
previous set up details and check for any changes.
4. Close off the fuel supply to the burner.
5. Ensure that the boiler has been cooled to ambient
temperature.
6. Isolate the mains supply to the boiler and burner.
7. Open the combustion chamber door after disconnecting the
supply pipe to the burner.
Vanguard L -
Installation & Servicing
SERVIcING
8. Remove the nuts and swing the burner door open
to clean the burner. (Refer to burner manufacturers
instructions)
9. Remove the turbulators.
10. Thoroughly clean the flue tubes and turbulators.
11. Remove the rear cleanout covers and dispose of the
debris/soot that may have accumulated.
12. Replace the rear cleanout covers after first inspecting
and if necessary replacing the seal.
13. Replace the flue turbulators into the flue tubes.
14. Check the condition of the combustion chamber door
insulation.
15. Check the condition of the combustion chamber door
seal.
16. Close the combustion chamber door.
17. Re-assemble the burner connections
18. After completion of servicing refer to previous frame for
reference to final safety checks.
19. Complete the log book.
31