Flame Inspection - IDEAL VANGUARD L 170 Installation And Servicing

25 BuRNER
The Vanguard boiler range is suitable for use with oil, gas, or
dual fuel burners. Nuway, EOGB and Riello burners can be
supplied as standard.
Burners from other manufacturers can be supplied on request.
Burners will be supplied for on/off or high/low operation.
Modulating burners can be supplied on request.
Burner Door
Burner doors have been pre-drilled to match the standard
burners offered. Should another manufacturer's burner be used
then it is the responsibility of the burner manufacturer to match
the burner to the doors available.
Burner mounting
When mounting the burner to the boiler front door, check for
soundness around the burner flange and its gasket. Each boiler
is supplied with a length of ceramic fibre rope (cross section
25x25 mm). This rope has to be put around the burner tube to
completely seal the tube and the hole in the door insulation.

26 fLAmE INSPEcTIoN

The Vanguard boiler range is provided with a
sightglass tube placed above the burner door.
The sightglass tube has a thread (1) suitable for
a pressure gauge and or for a cooling line (2) (not
supplied) connection as shown in the diagram.
24
INSTALLATIoN
Gas Supply
The gas supply MUST be sized in accordance with British Gas
recommendations and be prefabricated in compliance with
331 Pt 1 and any Local Gas Board installation standards.
The Local Gas Board should be contacted, at a stage prior to
installation, for any advise or information required. Details and
advice, relating to the use of L.P.G. for firing the Ideal Vanguard L
range of boilers, are available on request to Ideal.
oil Storage Tank
The oil storage tank, oil supply pipe and connections to the burner
unit MUST comply with the requirements of BS 779 and CP 5410.
The installation should conform to the recognised standards of
good practice in the trade and comply with the relevant Codes
of Practice, Building Regulations and Local Authority, Fire and
Insurance requirements.
2
1
Vanguard L -
Installation & Servicing
CP