Table of Contents
Advertisement
(3). Hang the latch, which is located on the opposite side of the swing flap motor on the panel.
temporarily to the book of the indoor unit. (2 Positions)
(4). Temporarily hang the remaining 2 latches to the hooks on the sides of the indoor unit.(be
careful not to let the swing motor lead wire get caught in the sealing material.)
(5). Screw all 4 hexagon head screws located right beneath the latches in approximately 15mm.
(panel will rise)
(6). Adjust the panel by turning it to the arrowed direction as below, so that the ceiling opening is
completely covered.
(7). Tighten the screws until the thickness of the sealing material between the panel and the
indoor unit body is reduced to 5~8 mm.
Precautions:
♦ Improper screwing of the screws may cause the troubles.
Cassette Type Fan Coil Unit Owner's Manual
14
Advertisement
Table of Contents
