Table of Contents
Advertisement
Cassette Type Fan Coil Unit Owner`s Manual
Warning:Before obtaining access to terminals,all supply circuits must be disconnected.
7.5 Electric wiring
(1). All field supplied parts and meterials must conform to local laws and regulations.
(2). For electric wiring, refer to "WIRING DIAGRAM" attached to the unit body.
(3). A1l wiring must be performed by a skilled technician.
(4). A circuit breaker capable of shutting down power supply to the entire system and which have
at least 3 mm contact seperation in each hole must be install in the fixed wiring.
(5). Earth properly.
(6). Wiring must conform to national laws and regulations.
(7). The fixed wiring must be installed with a protector with not more that 30mA leakage current.
(8). If the supply cord is damaged, it must be replaced by the manufactory or its service agents
or a similarity qualified person in order to avoid a hazard.
7.5.1Wiring of the indoor unit.
Remove the control box lid (l),pull the wires inside through rubber bush I and wiring according to
the "WIRING DIAGRAM'' then tighten it with clamp.
7.5.2 Wiring of the controller
Remove the control box lid (2).pull wires inside through rubber bush II and connect to the
controller.
Wrap the wire with sealing pad (12).
After wiring tighten it with clamp and fix the control box lid (1),(2).
Heating and cooling: connect the rubber wire (5-cords) to the power supply terminal board in
properly.
Cooling: connect the rubber wire (3-cords) to the power supply terminal board properly.
7.6 Installation of panel
(1). Set the panel to the indoor unit body by matching the position of the swing flap motor of the
decoration panel to the piping position of the panel to the piping position of the indoor unit .
(2). Install the decoration panel
13
Advertisement
Table of Contents
