Technical Specifications - K-array KU210 User Manual

KU210

11. TechnIcal sPecIfIcaTIons

Power handling
Impedance
Frequency range (-10 dB)
SPL 1W/1mt
Maximum SPL
Horizontal
Vertical
Frequency
Connectors
Wiring
Dimensions
Weight
ACOUSTICS
2 x 160 W
4 / 16 Ω selectable (2 x 8 Ω)
40 Hz – 300 Hz
94 dB
(2)
121 dB (cont.) – 127 dB (peak)
COVERAGE
omni
omni
CROSSOVER
Type External crossover required
Low pass @ 150 HZ suggested
TRANSDUCERS
Type 1 x 10" Neodymiun magnet with 2" voice coil
Type 1 x 10" passive transducer
POWER AUDIO IN/OUT
1 x 4-pin connector
Pin 1=Ch 1+, Pin 2=Ch 1-, Pin 3=Ch 2+, Pin 4=Ch 2-
RECOMMENDED AMPLIFIERS
Type KA14, KA24
CERTIFICATION
IP 54
PHYSICAL
50 cm x 28.2 cm x 15 cm (19.68" x 11.1" x 5.9")
11 Kg (24.25 lb)
Notes for data
1. With dedicated preset;
2. Measured @4 mt then scaled @1 mt;
3. Measured with musical signal
New materials and design are introduced into existing products without previous notice.
Present systems may differ in some respects from those presented in this catalogue.
(1)
(3)
rev. A
16