11–Fibre Channel Over Ethernet
FCoE Boot from SAN
3.
In the FCoE Target Parameters window, there are eight target entries in
which you can enable the target (Connect n), select or type a WWPN
(WWPN n), and type a boot LUN number (Boot LUN n)
The first six target entries (1-6) enable you to select a WWPN from a menu.
Use the UP and DOWN arrows to select the WWPN field, and then press
ENTER. In the WWPN list, use the UP and DOWN arrows to select a
WWPN, and then press ENTER.
The last two target entries (7, 8) enable you to type a WWPN. In the WWPN
field, type the WWPN, and then press ENTER.
4.
Press ESC until prompted to exit and save changes.
Figure 11-8. FCoE Target Parameters Window
Figure 11-9. Selecting an FCoE WWPN
222
(Figure
11-8).
83840-546-00 D