Viewing Hardware Information; Information Tab: Hardware; Configuring Adapter Parameters; Hardware And Resource Configuration Wizard: Port Configuration - Qlogic 8400 Series User Manual

8–Using QLogic Control Suite
Managing the Network Adapter

Viewing Hardware Information

The Hardware section of the Information tab displays information about the
hardware settings for the selected network adapter.
NOTE
Some information may not be available for all QLogic network adapters.

Information Tab: Hardware

ASIC Version The chip version of the QLogic adapter (this information is not
available for adapters made by others).
Bootcode Version The version of the boot code. This information is only
available for QLogic 8400/3400 Series adapters.
Family Firmware Version The global firmware version that represents all
firmware on the device.
Management Firmware The firmware version installed on the system.
Vendor ID The vendor ID.
Device ID The adapter ID.
Subsystem Vendor ID The subsystem vendor ID.
Subsystem ID The subsystem ID.
iSCSI Boot Version The version of the iSCSI Boot software initiator.
External PHY Firmware Version The external PHY firmware version.

Configuring Adapter Parameters

Select the network adapter in the Explorer View pane, and then select the
Configuration tab to configure adapter-level parameters.
Hardware and Resource Configuration Wizard: Port
Configuration
Select a port to configure, and then click Next.
Flow Control The possible values are Auto, Tx Pause, Rx Pause, Tx/Rx pause,
and Disable. The configuration is done at the port level and applies to all functions
under the port.The flow control value is a default value for the port. The effective
configuration can be different based on the switch port configuration and whether
or not DCB/DCBX is enabled.
Link Speed Configure the link speed. The default speed is 10Gb for 10Gb
adapters.
99 83840-546-00 D