Ql2X00Ip Ndis Driver And Ip Address Configuration; Driver Configuration; Ql2X00Ip.sys Configuration Parameters - Qlogic SANblade 2300 Series User Manual


6. Remove the disk that contains the QLogic driver.
7. Restart your system to load the updated driver.
5.5.3

QL2x00IP NDIS Driver and IP Address Configuration

You must configure the IP address and modify the driver parameters during the
initial configuration as specified in
appropriate using the following procedures.
5.5.3.1

Driver Configuration

The QL2x00IP NDIS driver provides configuration parameters. The driver
configuration parameters are listed in
paragraphs.
Table 5-1. Ql2x00ip.sys Configuration Parameters
Parameter
MTU Size
Buffer Count
Buffer Size
Header Split Size
Adapter Node Name
Table Notes
a
A value of 0 indicates that the headers and data are not split.
MTU Size. This parameter specifies the maximum transfer or packet size
that the host system sends or receives. All QLA22xx/QLA23xx HBAs on the
same network must have the same MTU size value. QLogic recommends
a default value of 8192.
Buffer Count. This parameter specifies the number of receive buffers that
the QL2x00IP driver allocates during initialization. The number of buffers
multiplied by the buffer size must be greater than or equal to the MTU size.
QLogic recommends a default value of 32.
Buffer Size. This parameter specifies the size of each receive buffer. The
buffer size multiplied by the number of buffers must be greater than or equal
to the MTU size. Incoming packets cannot be broken into more than
23 buffers. Therefore, the buffer size multiplied by 23 must be at least as
large as the MTU size. QLogic recommends a default value of 4096.
FC2354601-00 A
5 – Windows NT Driver Installation
QL2x00IP NDIS Network Driver Installation
section 5.5.1. You can also modify these later as
table 5-1 and described in the following
Minimum
92
8
512
24 Buffer size –1
—
Recommended
Maximum
65280
128
65536
—
Default
8192
32
4096
a
0
—
5-7