Configuring The Ip Address For Iscsi Offload; Viewing Licenses - Qlogic 8400 Series User Manual

8–Using QLogic Control Suite
Viewing Resource Information

Configuring the IP Address for iSCSI Offload

For iSCSI-booted adapters, the Configurations tab is not available and you will not
be able to perform this procedure.
To set the IP address of the iSCSI HBA for iSCSI offload
The iSCSI Management section of the Configurations tab allows you to set the
IP address of the iSCSI HBA when using iSCSI protocol to offload network
processing from the CPU to the QLogic network adapter.
1. Click the name of the QLogic 8400/3400 Series iSCSI device in the SCSI
controller section of the Explorer View pane.
2. Depending on the protocol you will be using, for IPv4 DHCP or IPv6 DHCP,
select Enable (not available for iSCSI booted adapters) to set the IP
address dynamically using a DHCP server. Or select Disable to set the IP
address using a static IP address. Enter the IP Address, Subnet Mask, and
Default Gateway.
3. Configure the VLAN ID for the iSCSI HBA by entering a number for VLAN
ID. The value must be between 1 and 4094.
4. After the configurations are complete, click Apply to save the settings or
click Reset to revert back to the previous settings.

Viewing Licenses

NOTE
 The Licenses section of the Configurations tab applies only to QLogic
 Not all offload technologies are available with all adapters.
The Licenses section shows the number of connections available for iSCSI FCoE
offload technologies.
To view licenses
Click the name of the QLogic 8400 Series system device in the Explorer View
pane.
8400 Series adapters.
128 83840-546-00 D